Operating Tips

SDS2000X Series

Standard probe product list

December 27, 2017

Here is a list of probes currently supplied with each product: Click here to view the Product Probe List

How to Capture a Runt Pulse with a SIGLENT SDS Oscilloscope

December 27, 2017

Capturing a Runt Pulse The new Super Phosphor Oscilloscope (SPO) technology supports deep memory, a fast waveform refresh rate and a 256 grey scale and color temperature waveform display. The intelligent Pass / Fail function is widely used in industrial electronic detection. The technology also includes powerful intelligent triggering (window, interval, timeout, pattern, Runt). Here … Continued

Adjusting measurement font size with the SDS2000X series

December 22, 2017

You can increase the font size used for the measurement functions of the SDS2000X series. To activate this function: – Press Utility > Do Self Cal (Page 1/3). This will bring up the Self Cal warning: – From the warning page, press Cursors 1 time > Measure 1 time > Display/Persist two times > Measure 1 … Continued

How to save to an external USB with the SDS series of oscilloscopes

December 22, 2017

The SDS series of SIGLENT Digital Oscilloscopes have a number of save options that include copies of the displayed image (Bitmap, JPG, and PNG are common image types) as well as instrument configurations (Setups) and data (CSV). Here are brief instructions on how to save files to external USB memory devices. Insert a USB memory … Continued

What instruments accept SCPI commands for remote control?

October 25, 2017

All SIGLENT instruments (except for the SHS1000 and SHS800 hand-held oscilloscopes) support SCPI remote control commands. For more information, download the specific instrument programming guide located on the product page.

SIGLENT X and X-E series oscilloscopes Sequence and History mode

October 25, 2017

With the advance of science and technology, more demands are being placed upon stability, performance, and the intelligence of electronic products. Product design engineers face many problems with the verification and debugging of high-speed signals. A typical example is intermittent glitches with some low duty cycle signals, such as laser pulses, metastable low-duty radar pulses or … Continued

Oscilloscope Hardware Reset

October 25, 2017

In some extreme hardware errors, the oscilloscope may become unresponsive or “hang” during the boot sequence. If your oscilloscope is frozen, will not boot, or appears to be unresponsive, you can attempt a hardware reset by following these instructions: 1. Disconnect all USB, LAN, and input cables. Leave the power cord connected. 2. Power cycle … Continued

How to Extract Data from the Binary File of SDS2000X, SDS1000X, and SDS1000X-E

October 25, 2017

Table 1 Format of the Binary File Address Parameter Description 0x00-0x03 wave_length Reserved 0x04-0x07 mso_wave_length digital channels wave length 0x10-0x13 mso_ch_open_num Total enabled digital channels 32-bit signed integer, little endian. 0x14 mso_ch_open_state[0] on/off status of digital channel 0 (D0), 1 – ON, 0 – OFF 8-bit unsigned integer. 0x15 mso_ch_open_state[1] on/off status of digital channel … Continued

How to install options on the SDS2000 and SDS2000X Series of Oscilloscopes

October 25, 2017

The SIGLENT SDS2000 and SDS2000X Series of Oscilloscopes have multiple options to fulfill your measurement requirements. You can view the options currently installed on the oscilloscope or activate the newly bought option serial number through the Utility menu. To install an option: 1. Press the Utility button on the front panel to enter the UTILITY … Continued